An Easy-To-Follow Guide To Fiat 500 Replacement Key Cost

Fiat 500 Replacement Key Fob

If your remote key fob has stopped working, it's time to replace the battery. However, if you replace the battery but it continues to stop working then the issue is likely to be elsewhere.

United Locksmith specializes in the production of new keys for classic cars. We have the tools and parts required for this service.

Dead Coin Battery

The most frequent reason that your fiat 500 keys 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob comes with an internal battery called a coin cell which will quickly drain if it is not utilized frequently enough. If your remote began to show signs of weakness like a loss of range and then completely stopped working the battery could be dead.

Metal clips keep the battery securely inside the key fob. If the clips are loose they can cause contact issues, which could prevent your remote from receiving power. With a small flathead screwdriver, pull the retaining clip outwards to take out the battery and replace it with a new one. Make sure you use an alternative battery that has the same kind of voltage, size and specifications as the original battery.

The exposure to water can cause the key fob to corrode, or even become damaged. Even a brief bath in warm, soapy water could cause damage to the chip. It is best to keep your key fob in a dry location.

Water Damage

Water damage may be the reason for your key fob's inability to function properly. Key fobs are fitted with rubber seals that prevent them from being damaged by a light rain or a splash of water, but it is very important to keep your car keys safe from the ocean, pool, and the washing machine!

The key fob is equipped with an electronic chip that sends an immobilizer system of your vehicle. The chip is what allows the 500 to lock and start. If it gets wet it will not function.

Try cleaning the inside of your key fob's electronics with isopropyl alcohol or an electronic cleaner to determine if they are still good. However, it is probably better to purchase a replacement from a dealer instead of trying to repair the key fob which was submerged in salt water.

A replacement fob could cost you a few dollars however, it's less expensive than paying to have your fiat panda key 500 towed to a dealer and repaired there! Plus, you can do it yourself with a few easy steps. Be sure to have the correct battery type before attempting to open your key fob. This is a job that's far simpler than it appears, and you can find step-by-step instructions online for almost any key fob in your car.

Faulty Chip

The chip inside the key fob communicates with your car's immobiliser unit to make sure the car is able to start when the correct key is used. If the chip is damaged, or corrupted the car will not start regardless of what you do.

Water damage or a dead battery are the two most common causes of an unreliable chip. Regardless of the reason, it is best to delegate the work to a locksmith as they can replace the chip for you swiftly and at a reasonable cost.

If your key fob ceases to function after exposure to clean tap water or rain, unplug the battery and wipe down the electronic component with a paper towel to ensure it is fully dry before putting it back into. If the key fob isn't working it's probably an issue with the chip and will need to be replaced.

Some people will turn to their dealer when in need of an entirely new Fiat key fob, however it can be a expensive alternative. If you are looking for a low-cost solution to get your fiat 500x key not detected panda remote Key replacement (bailey-Lara.Technetbloggers.de) key fob fixed then look no further than United Locksmith. We have the tools and experience needed to fix your fiat 500 car key replacement fob in a timely and professional way.

Faulty Receiver Module

Fiat key fobs send an electronic signal to the vehicle that can unlock and lock doors (and start the car if it has an automatic transmission) up to 50 feet. However, there are some things that can cause the fob to stop working. This can be caused by a dead coin-battery or water damage, worn-out buttons, a receiver issue, signal interference or a malfunctioning chip.

If the fob was in a pocket which has suffered a severe trauma, like being dropped on hard floors or getting washed in a washer and it isn't capable of communicating with the car's Body Control Module (BCM). The BCM is a security device that can only accept signals from genuine keys.

You'll have to replace the fob in case this happens. A professional locksmith will manage the entire replacement process including programming a new one for your 500. They can even offer an clone fob that performs the same as the original (and costs only one-third of the price).