Home Depot Water Filtration Systems
What's all the fuss about home depot's water softeners? Are they worth the price and hassle of installation? Read ahead for more information on these DIY er products, what they're used for and if they're right for your home. If you'd like to find out more about plumbing then this article should help you out.
Home depots sell water softeners made by Brinkmann, Kiplim and Kenmore. All three brands are well-known, but they all use different methods for softening water. Brinkmann make their own water softeners by using a combination of sodium bicarbonate and potassium phosphate. They claim this reduces the effect of hard water on pipes and equipment. Kenmore do the same by using a combination of calcium bicarbonate and magnesium chloride.
Home depot plumbingsupply installers claim that installing these fittings correctly can save you up to 50% in cost. If you don't feel confident doing this yourself then they have an expert plumber at their disposal. Installation usually takes two hours, but this may vary depending on whether the depot has their own plumber or not. The installation is quick, so if you have a busy lifestyle it shouldn't take too long. If you do decide to get one of these units from them then you'll need to have a cold water supply as they work from a low pressure.
You then connect your water pipe to the main line with a T connector. You may also need to buy some special adapters, but these can be bought separately. Once this is done, you simply leave the T connector in place and check your system to see if there's any leaks. These usually only leak if you're not watching the pipes closely enough - it's the brinksmanship that causes most problems.
After this you just need to connect the faucet to the water filtration system. There is typically a hose at the end of the plumbing section so you can easily reach it. If it looks OK, you can put the assembly in place and run the water through it, checking the pressure gauge to ensure that it's working properly. If there is a problem you shouldn't try to fix it on your own.
As mentioned earlier, the whole system requires a cold water supply and it works very well with dishwashers. This means that all you need to worry about is ensuring that it gives you the right level of water pressure at all times. This is made a lot easier by the fact that dishwasher pressure is measured in gallons and you can set your system up accordingly. If you're planning on installing the system yourself then you will need to make sure that you get the correct pressure requirements for your appliances. If you have any issues relating to wherever and how to use homepage, you can get hold of us at our page. If you're not sure what these are, then you should contact the home depot technical department.
